All power take-offs are particularly designed for traveling hydraulic pumps to SAE J744C series ‘B’ specification with splined insight shaft and either two-bolt or four-bolt fixing. The utmost power which can be transmitted is definitely 22 KW (29.5 bhp) per 1000 rev/min engine speed; this equates to a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off gives pump rotation exactly like the engine, where as the direct drive power take-off for the PRM500 and PRM750 gives opposite rotation. Power to the pump is not affected by the standard utilization of the gearbox for propulsion responsibilities. All ancillary power circuits driven by PRM power take-offs ought to be designed in accordance with the recommendations of the hydraulic apparatus manufacturer, and really should be properly safeguarded against overloading.
PRM power take-off systems fit on the trunk face of the main gearcase and so are driven by the insight shaft; consequently they could be operated all the time whilst the engine is usually running, The power take-off replaces the finish cover which is normally fitted and performs the features of the end cover by sealing the gearbox against lack of oil and correctly positions the insight shaft back bearing. Power take-off devices provide the link between the gearbox and the hydraulic pump.

Direct Drive Power Take-Off
Available on the PRM500 and PRM 750 the immediate drive power take-off is certainly driven directly from the gearbox input shaft; consequently it will operate all the time when the engine is running, and since there is no clutch for disengagement of the hydraulic pump, provision must be manufactured in the auxiliary hydraulics circuits for pressure by-complete to the reservoir when capacity to the pump is not required. A set of 1:1 ratio gears, providing enough offset between the gearbox output shaft and the centreline of the energy take-off to ensure there is adequate clearance between your hydraulic pump and propeller shaft coupling.

Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Extended length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that suits a groove on input shaft of rotary mower

Are you losing time trying to find pto gearbox on various other web sites?