As servo technology has evolved-with manufacturers making smaller, yet better motors -gearheads are becoming increasingly essential partners in motion control. Finding the optimal pairing must take into account many engineering considerations.
• A servo motor working at low rpm operates inefficiently. Eddy currents are loops of electrical current that are induced within the electric motor during procedure. The eddy currents in fact produce a drag pressure within the motor and will have a greater negative impact on motor efficiency at lower rpms.
• An off-the-shelf motor’s parameters might not be ideally suitable for run at a minimal rpm. When an application runs the aforementioned motor at 50 rpm, essentially it isn’t using all of its available rpm. As the voltage continuous (V/Krpm) of the motor is set for a higher rpm, the torque constant (Nm/amp)-which is certainly directly related to it-is certainly lower than it requires to be. Consequently, the application needs more current to drive it than if the application had a motor specifically created for 50 rpm. A gearhead’s ratio reduces the motor rpm, which is why gearheads are sometimes called gear reducers. Utilizing a gearhead with a 40:1 ratio,
the engine rpm at the input of the gearhead will be 2,000 rpm and the rpm at the output of the gearhead will be 50 rpm. Operating the electric motor at the higher rpm will permit you to avoid the concerns

Servo Gearboxes provide freedom for how much rotation is achieved from a servo. Many hobby servos are limited by just beyond 180 examples of rotation. Many of the Servo Gearboxes use a patented exterior potentiometer to ensure that the rotation quantity is independent of the gear ratio installed on the Servo Gearbox. In such case, the small gear on the servo will rotate as much times as necessary to drive the potentiometer (and hence the gearbox result shaft) into the position that the signal from the servo controller calls for.
Machine designers are increasingly turning to gearheads to take advantage of the latest advances in servo electric motor technology. Essentially, a gearhead converts high-speed, low-torque energy into low-speed, high-torque result. A servo engine provides highly accurate positioning of its output shaft. When both of these devices are paired with one another, they promote each other’s strengths, offering controlled motion that is precise, robust, and reliable.

Servo Gearboxes are robust! While there are high torque servos in the marketplace that doesn’t indicate they can compare to the load capability of a Servo Gearbox. The small splined output shaft of a normal servo isn’t lengthy enough, huge enough or supported well enough to take care of some loads despite the fact that the torque numbers appear to be appropriate for the application form. A servo gearbox isolates the strain to the gearbox output shaft which is backed by a set of ABEC-5 precision ball bearings. The exterior shaft can withstand extreme loads in the axial and radial directions without transferring those forces to the servo. In turn, the servo runs more freely and is able to transfer more torque to the result shaft of the gearbox.